Users Guide

70 Instrumentation Service
The Remote Access object action window can have the following tabs, depending on the user's group
privileges: Properties, Configuration, and Users.
Properties
Subtab: Information
Under the Properties tab, you can view general BMC or DRAC information. Click Reset to Defaults to
reset all the attributes to their system default values.
Configuration
Subtabs: LAN | Serial Port | Serial Over LAN
Under the Configuration tab when BMC is configured, you can configure the BMC on a LAN, serial
port for BMC, and BMC on a serial over LAN connection.
Under the Configuration tab when DRAC is configured, you can:
• Configure network properties
• Configure SNMP traps
• Configure demand dial-out entries
• Configure dial-in users
• Configure remote properties such as remote boot parameters
• Configure modem properties
NOTE: The Enable NIC, NIC Selection, and Encryption Key fields display only on Dell PowerEdge x9xx systems.
Users
Subtab: Users
Under the Users tab, you can modify the remote access user configuration. You can add, configure, and
view information about Remote Access Controller users.
NOTE: On the Dell PowerEdge x9xx systems:
• Ten user IDs are displayed. If a DRAC card is installed, sixteen user IDs are displayed.
• Serial Over LAN Payload column is displayed.
Slots
Clicking the Slots object allows you to manage the connectors or sockets on your system board that accept
printed circuit boards, such as expansion cards. The Slots object action window has the Properties tab.
Properties
Subtab: Information
Under the Properties tab, you can view information about each slot and installed adapter.