Messages Reference Guide

66 Storage Management Message Reference

2057 Virtual disk degraded Warning /

Non-critical

Cause 1: This alert message occurs when a

physical disk included in a redundant virtual

disk fails. Because the virtual disk is redundant

(uses mirrored or parity information) and

only one physical disk has failed, the virtual

disk can be rebuilt.

Action 1: Configure a hot spare for the virtual

disk if one is not already configured. Rebuild

the virtual disk. When using an Expandable

RAID Controller (PERC) PERC 3/SC,

3/DCL, 3/DC, 3/QC, 4/SC, 4/DC, 4e/DC,

4/Di, CERC ATA100/4ch, PERC 5/E, PERC

5/i or a Serial Attache SCSI (SAS) 5/iR

controller, rebuild the virtual disk by first

configuring a hot spare for the disk, and then

initiating a write operation to the disk. The

write operation will initiate a rebuild of the

disk.

Cause 2: A physical disk in the disk group has

been removed.

Action 2: If a physical disk was removed from

the disk group, either replace the disk or

restore the original disk. You can identify

which disk has been removed by locating the

disk that has a red “X” for its status. Perform

a rescan after replacing the disk.

None 1203

2058 Virtual disk check

consistency started