Messages Reference Guide

128 Index
128 Index
The enclosure cannot support
both SAS and SATA
physical disks. Physical
disks may be
disabled., 103
The enclosure has a hardware
error., 102
The enclosure is not
responding., 102
The enclosure is
unstable., 102
The enclosure temperature
has returned to
normal., 112
The factory default settings
have been restored., 110
The firmware on the EMMs is
not the same version.
EMM0 %1 EMM1 %2, 105
The global hot spare is too
small., 97
The initialization sequence of
SAS components failed
during system startup.
SAS management and
monitoring is not
possible., 105
The non-RAID SCSI driver
version is older than the
minimum required
level.See the Readme file
for the validated driver
version., 86
The NVRAM has corrupt
data., 108
The NVRAM has corrupted
data. The controller is
reinitializing the
NVRAM., 108
The only hot spare available is
a SAS disk. SAS disks
cannot replace SATA
disks., 92
The only hot spare available is
a SATA disk. SATA disks
cannot replace SAS
disks., 92
The Patrol Read corrected a
media error., 96
The patrol read has
resumed., 99
The Patrol Read has
started., 93
The Patrol Read has
stopped., 93
The Patrol Read is paused., 99
The Patrol Read mode has
changed., 93
The Patrol Read rate has
changed., 93
The physical disk blink has
ceased., 94
The physical disk blink has
initiated., 94
The physical disk Clear
operation failed., 96
The physical disk Clear
operation has
completed., 96
The physical disk Clear
operation has started., 94
The physical disk has been
started., 94
The physical disk is not
certified., 113
The physical disk is not
supported., 92
The physical disk is too small
to be used for a
rebuild., 103
The physical disk rebuild has
resumed., 97
The power supply cable has
been inserted., 107
The power supply is switched
on., 107
The RAID controller firmware
and driver validation was
not performed. The
configuration file cannot
be opened., 85
The RAID controller firmware
and driver validation was
not performed. The
configuration file is out of
date or corrupted., 85
The rebuild failed due to
errors on the source
physical disk., 111
The rebuild failed due to
errors on the target
physical disk., 112