Messages Reference Guide

Storage Management Message Reference 103
2303 The enclosure
cannot support both
SAS and SATA
physical disks.
Physical disks may
be disabled.
Ok / Normal Cause: This alert is for informational purposes.
Action: None
None 851
2304 An attempt to hot
plug an EMM has
been detected. This
type of hot plug is
not supported.
Ok / Normal Cause: This alert is for informational purposes.
Action: None
None 751
2305 The physical disk is
too small to be used
for a rebuild.
Warning /
Non-critical
Cause: This alert is for informational purposes.
Action: Use a physical disk that is the same
size or larger than the physical disk being
replaced. See the Replacing a Failed Disk
section in the Dell OpenManage Server
Administrator Storage Management User’s
Guide for more information.
None 905
2306 Bad block table is
80% full.
Warning /
Non-critical
Cause: The bad block table is used for
remapping bad disk blocks. This table fills,
as bad disk blocks are remapped. When the
table is full, bad disk blocks can no longer be
remapped, and disk errors can no longer be
corrected. At this point, data loss can occur.
The bad block table is now 80% full.
Action: Back up your data. Replace the
disk generating this alert and restore from
back up.
None 903
Table 4-4. Storage Management Messages (continued)
Event
ID
Description Severity Cause and Action Clear
Event
Number
SNMP
Trap
Numbers