Compatibility Guide
84 Historical Release Information for Legacy Systems
New in Server Agent Version 4.3.0
This release adds support for the following Dell systems:
• PowerEdge 2500
• PowerEdge 2550
Server Agent 4.3.0 Resolved Issues
• Hung server alerts for PowerEdge 8450 systems
When you configure the hung server action for a Dell PowerEdge 8450 system, the system either
performs a system reset or a recycle system power action.
• PowerEdge 350 issues
This release addressed the following Dell PowerEdge 350 issues that were originally addressed by
Dell OpenManage Server Agent 4.2.0 Update 1:
– Changes thresholds for the -12 volt (V) voltage probe on the system board. These new thresholds
prevent erroneous probe failures and warnings.
– Corrects erroneous fan failure reports in the event log.
– Corrects system crashes at start-up caused by incorrect event log record length.
– Disables the chassis identification feature.
•Dell PowerVault™ 2
xx
S SCSI disk systems and SNMP
This release addresses the following PowerVault 2
xx
S SCSI disk system issue that was originally
addressed by Server Agent 4.2.0 Update 1:
– Allows Dell PowerEdge systems attached to the PowerVault 2
xx
S SCSI disk system to respond to
SNMP requests for information. Under certain rare circumstances, some Dell systems with
PowerVault 2
xx
S attached were not responding to SNMP requests.
Server Agent 4.2.2
The following subsections contain requirements, features, and open issues for Server Agent version 4.2.2.
Release date: February 2001
Requirements
Supported systems: Dell PowerEdge 300, 350, 1300, 1400, 1550, 2300, 2400, 2450, 4300, 4350, 4400,
6300, 6350, 6400, 6450, and 8450