User's Manual

90 omconfig: Managing Components Using the Instrumentation Service
To clear the contents of the command log, type:
omconfig system cmdlog action=clear
To clear the contents of the ESM log, type:
omconfig system esmlog action=clear
omconfig system pedestinations
Use the omconfig system pedestinations command to set IP addresses for alert destinations.
Table 4-21 shows the valid parameters for the command.
NOTE: You can either specify the index and IP address as parameters together OR you can set the community
string as a parameter alone.
omconfig system platformevents
Use the omconfig system platformevents command to configure shutdown action, if any, to be taken for a
specific platform event. You can also enable or disable platform event filter alert generation.
NOTICE: If you set a platform event shutdown action to anything other than "none", your system will forcefully
shutdown when the specified event occurs. This shutdown is initiated by firmware and is carried out without first
shutting down the operating system or any of the applications running on your system.
Table 4-22 shows the valid parameters for the command.
NOTE: Alert settings are mutually exclusive and can be set one at a time only. The action settings are also mutually
exclusive and can be set one at a time only. However, alert and action settings are not mutually exclusive of
each other.
Table 4-21. omconfig system pedestinations
name=Value Pair Description
destenable=true | false true: Enables an individual platform event filter destination after a valid IP address
has been set.
false: Disables an individual platform event filter
.
index=number Sets the index for the destination.
ipaddress=ip address Sets the IP address for the destination.
communitystr=text Sets the text string that acts as a password and is used to authenticate SNMP
messages sent between the BMC and the destination management station.