User's Manual

omconfig rac: Managing the Remote Access Controller 129
Example Command
The following example sets one name=value pair. Type:
omconfig rac rmsnmptrap ipaddr=123.199.152.216
The following message appears:
Command Successful. Please reset RAC card!
omconfig rac rmuser
Use the omconfig rac rmuser command to remove a user. Table 7-13 shows the valid parameters for
the command.
Example Command
The following example sets one name=value pair. Type:
omconfig rac rmuser username=jdoe
The following message appears:
Command Successful. Please reset RAC card!
omconfig rac reset
Use the omconfig rac reset command to reset the RAC.
omconfig rac uploadcert
Use the omconfig rac uploadcert command to upload the server or CA certificate to the RAC. You must
enter the fully qualified pathname of the certificate and select the type of certificate to upload. The two
types of certificate that you can upload are a server certificate, or a certificate that you can obtain from a
certificate authority (CA). Examples of certificate authorities are Thawte Server CA or VeriSign, Inc.
NOTE: This command makes use of the FTP protocol to communicate with the RAC firmware. The command may
fail if firewall software is installed in the system.
Table 7-14 shows the valid parameters for the command.
Table 7-13. omconfig rac rmuser
name=value pair Description
username=<text> Specifies the user name of entry which is to be deleted. If no user name is
specified, an index must be specified.
index=<n> Specifies the index of the entry which is to be deleted. If no index is
specified, a user name must be specified.