CIM Reference Guide

22 CIM_PhysicalElement
MemoryType
(continued)
17 SDRAM
18 SGRAM
19 RDRAM
20 DDR
21 DDR2
DDR2 FB-DIMM
TotalWidth Indicates the total width, in bits, of the physical memory, including
check or error correction bits. If there are no error correction bits, the
value in this property should match that specified for the DataWidth
property.
uint16
DataWidth Indicates the data width, in bits, of the physical memory. A data width
of 0 and a total width of 8 would indicate that the memory is solely used
to provide error correction bits.
uint16
Speed Indicates the speed of the physical memory, in nanoseconds. uint32
SpeedAsString Indicates the accurate speed of the physical memory, in string format
(with units).
string
Capacity Indicates the total capacity of this physical memory, in bytes. uint64
BankLabel A string identifying the physically labeled bank where the memory is
located, for example, "Bank 0" or "Bank A."
string
PositionInRow Specifies the position of the physical memory in a “row.” For example,
if it takes two 8-bit memory devices to form a 16-bit row, then a value of
2 means that this memory is the second device. 0 is an invalid value for
this property.
uint32
InterleavePosition Indicates the position of this physical memory in an interleave.
0 indicates noninterleaved. 1 indicates the first position, 2 the second
position and so on. For example, in a 2:1 interleave, a value of
1 indicates that the memory is in the “even” position.
uint32
Table 2-8. CIM_PhysicalMemory Properties (continued)
Class Name: CIM_PhysicalMemory
Parent Class: CIM_Chip
Property Description Data Type