Reference Guide
Traps 587
Memory Device Traps
Memory device messages provide status and warning information for memory modules present in a
particular system. Memory devices determine health status by counting the number of ECC memory
corrections.
NOTE: A value of failure or non-recoverable does not indicate a system failure or loss of data, but rather
that the specified system exceeded the specified ECC correction threshold. Although the system continues to
function, you should perform system maintenance as described in Table 25-10.
Table 25-10. Memory Device Messages
Trap ID Description Severity Cause
1403 Memory device status is <
status
>
Memory device location:
<
Location in chassis
>
Possible memory module event
cause:
<list of causes>
Warning A memory device correction rate
exceeded an acceptable value. The
memory device status and location are
provided.
1404 Memory device status is <
Status
>
Memory device location:
<
Location in chassis
>
Possible memory module event
cause: <list of causes>
Error A memory device correction rate
exceeded an acceptable value, a memory
spare bank was activated, or a
Uncorrectable Memory Event occurred.
The system continues to function
normally (except for a Uncorrectable
Memory Event). Clear the memory
error on Uncorrectable Memory Event.
Replace the memory module identified
in the message during the system’s next
scheduled maintenance. The memory
device status and location are provided.