User's Manual

omconfig: Managing Components Using the Instrumentation Service 77
attribute=nic2 setting=enabled | disabled
| enablednonepxe
enabled: Enable the second NIC during
system boot (with PXE on if the system
has PXE).
disabled: Disable the second NIC during
system boot.
enablednonepxe: Enable the second
NIC during system boot (with PXE off if
the system has PXE).
attribute=numlock setting=on | off on: Use the keypad as number keys.
off: Use the keypad as arrow keys.
attribute=ppaddress setting=off | lpt1 | lpt2 | lpt3 off: Disable the parallel port address.
lpt1: Locate the device on LPT1.
lpt2: Locate the device onLPT2.
lpt3: Locate the device on LPT3.
attribute=ppmode setting=at | ps2 | ecp | epp at: Set the parallel port mode to type AT.
ps2: Set the parallel port mode to
type PS/2.
ecp: Set the parallel port mode to
type ECP (extended capabilities port).
epp: Set the parallel port mode to
type EPP (enhanced parallel port).
attribute=primaryscsi setting=on | off
force=true
NOTICE: If you modify the setting for
primary scsi, romb, romba, or rombb, your
system becomes inoperable until you
reinstall the operating system.
on: Enable this device.
off: Disable this device.
force=true: Verification of
setting change.
Table 5-2. BIOS Setup (continued)
name=value pair 1
attribute=
name=value pair 2
setting=
Description