User's Manual

omconfig: Managing Components Using the Instrumentation Service 75
attribute=crab setting=enable | disable enable: Enable BIOS console redirection
after system reboot.
disable: Disable BIOS console
redirection.
NOTE: The command crab is valid for Dell
PowerEdge 2900, 2950, 1950, and 1955
systems only.
attribute=cpuht setting=enable | disable enable: Enable logical processor hyper
threading.
disable: Disable logical processor hyper
threading.
attribute=cpuvt setting=enable | disable enable: Enable virtualization.
disable: Disable virtualization.
attribute=dbs setting=enable | disable enable: Enables Demand Based Power
Management (DBS) on the system.
disable: Disables DBS on the system.
attribute=diskette setting=off | auto | writeprotect off: Disable the diskette drive.
auto: Auto enable the diskette drive.
writeprotect
: Do not allow writes. Make
the diskette drive read only.
attribute=dualnic setting=off | onpxeboth |
onpxenone | onpxenic1 |
onpxenic2
off: The NICs are disabled.
onpxeboth: Both the NICs are PXE
enabled.
onpxenone: PXE is not enabled on
either of the NICs.
onpxenic1: PXE is enabled on NIC 1.
onpxenic2: PXE is enabled on NIC 2.
attribute=extserial setting=com1 | com2 | rad com1: Maps external serial connector to
COM 1.
com2: Maps external serial connector to
COM 2.
rad: Maps external serial connector to
remote access device.
Table 5-2. BIOS Setup (continued)
name=value pair 1
attribute=
name=value pair 2
setting=
Description