User's Manual

omreport: Viewing System Status Using the Instrumentation Service 57
omreport chassis pwrsupplies
Use the omreport chassis pwrsupplies command to view properties of your system’s power supplies.
Ty p e :
omreport chassis pwrsupplies index=
n
The index parameter is optional. If you do not specify the index, Server Administrator displays
properties for all power supplies in your system. If you specify the index, Server Administrator displays
properties for a specific processor.
For each power supply in the system, values display for the following fields: Status, Location, Ty p e , Max
Wattage, and Online Status.
omreport chassis remoteaccess
NOTE: This command is applicable to Dell ™ PowerEdge x8xx and x9xx systems only.
Use the omreport chassis remoteaccess command to view general information on baseboard
management controller (BMC) and remote access control (RAC) if DRAC is installed.
Ty p e :
omreport chassis remoteaccess
The output from the omreport chassis remoteaccess command lists each of the valid parameters.
Table 4-5 shows the available settings.
omreport chassis slots
Use the omreport chassis slots command to view properties of your system’s slots. Type:
omreport chassis slots index=
n
The index parameter is optional. If you do not specify the index, Server Administrator displays
properties for all of the slots in your system. If you specify the index, Server Administrator displays
properties for a specific slot.
Table 4-5. omreport chassis remoteaccess
name=value pair Description
config=advsol Reports advanced BMC or RAC information on a serial over local area
network (LAN) connection.
config=nic Reports BMC or RAC information for the LAN.
config=serial Reports serial port information for BMC or RAC.
config=serialoverlan Reports BMC or RAC information on a serial over LAN connection.
config=terminalmode Reports terminal mode settings for the serial port.
config=user Reports information on BMC or RAC users.