User's Manual

Using the Storage Management Service 201
omconfig Disable Enclosure Alarm
Use the following omconfig command syntax to disable the enclosure alarm.
Complete Syntax
omconfig storage enclosure action=disablealarm controller=id
enclosure=<ENCLOSUREID>
where id is the controller ID. The <ENCLOSUREID> variable specifies the enclosure.
Example for SCSI, SATA, and ATA Controllers:
For example, to disable the alarm on the enclosure attached to connector 2 on controller 1, enter:
omconfig storage enclosure action=disablealarm controller=1
enclosure=2
Example for SAS Controllers:
For example, to disable the alarm on enclosure 2 attached to connector 1 on controller 1, enter:
omconfig storage enclosure action=disablealarm controller=1
enclosure=1:2
omconfig Enable Smart Thermal Shutdown
The omconfig storage enclosure action=enablests command was supported in previous releases of
Storage Management. This command has been replaced by the omconfig storage globalinfo action=
enablests command. When enabling smart thermal shutdown and creating CLI scripts, it is preferable to
use the omconfig storage globalinfo action=enablests command.
See the "omconfig Global Enable Smart Thermal Shutdown" command for more information.
omconfig Disable Smart Thermal Shutdown
The omconfig storage enclosure action=disablests command was supported in previous releases of
Storage Management. This command has been replaced by the omconfig storage globalinfo action=
disablests command. When disabling smart thermal shutdown and creating CLI scripts, it is preferable to
use the omconfig storage globalinfo action=disablests command.
See the "omconfig Global Disable Smart Thermal Shutdown" command for more information.