User's Manual

188 Using the Storage Management Service
Example Syntax
For example, to change the read policy of virtual disk 4 on controller 1 to no-read-ahead, enter:
omconfig storage vdisk action=changepolicy controller=1 vdisk=4
readpolicy=nra
omconfig Rename Virtual Disk
Use the following omconfig command syntax to rename a virtual disk.
NOTE: On a CERC SATA 1.5/2s controller, you cannot change the default name of a virtual disk.
Complete Syntax
action=rename controller=id vdisk=id name=<string>
where id is the controller ID and virtual disk ID as reported by the omreport command and <string> is the
new name for the virtual disk. To obtain the values for controller ID and virtual disk ID, enter omreport
storage controller to display the controller IDs and then enter omreport storage vdisk controller=ID to
display the IDs for the virtual disks attached to the controller.
Example Syntax
For example, to rename virtual disk 4 on controller 1 to vd4, enter:
omconfig storage vdisk action=rename controller=1 vdisk=4 name=vd4
omconfig Array Disk Commands
The following sections provide the omconfig command syntax required to execute array disk tasks.
Table 9-23. omconfig Array Disk Commands
Required Command Levels (1, 2, 3) Optional name=value pairs
omconfig storage adisk
action=blink controller=id adisk=<ADISKID>
action=unblink controller=id adisk=<ADISKID>
action=remove controller=id adisk=<ADISKID>
action=initialize controller=id adisk=<ADISKID>
action=offline controller=id adisk=<ADISKID>
action=online controller=id adisk=<ADISKID>
action=assignglobalhotspare controller=id adisk=<ADISKID>
assign=<yes|no>
action=rebuild controller=id adisk=<ADISKID>