User's Manual

Using the Storage Management Service 167
omconfig Controller Commands
The following sections provide the omconfig command syntax required to execute controller tasks.
NOTICE: The omconfig storage controller action=resetconfig controller=id resets the controller configuration.
Resetting the controller configuration permanently destroys all data on all virtual disks attached to the controller. If
the system or boot partition resides on these virtual disks, it will be destroyed.
Table 9-16. omconfig Controller Commands
Required Command Levels (1, 2, 3) Optional name=value pairs
omconfig storage controller
action=rescan controller=id
action=globalrescan
action=enablealarm controller=id
action=disablealarm controller=id
action=quietalarm controller=id
action=testalarm controller=id
action=resetconfig controller=id [force=yes]
action=createvdisk controller=id raid=<c| r0| r1| r1c| r5| r10|
r50> size=<number | max | min> adisk=<ADISKID>
[stripesize=< 2kb| 4kb| 8kb| 16kb| 32kb| 64kb| 128kb>]
[cachepolicy=<d | c>] [readpolicy=<ra| nra| ara| rc| nrc>]
[writepolicy=<wb | wt | wc | nwc | fwb>] [name=<string>]
[spanlength=<n>]
action=setrebuildrate controller=id
rate=<0 to 100>
action=setbgirate controller=id
rate=<0 to 100 >
action=setreconstructrate controller=id
rate=<0 to 100>
action=setcheckconsistency controller=id
rate=<0 to 100>
action=exportlog controller=id
action=importforeignconfig controller=id
action=clearforeignconfig controller=id