User's Manual

150 omconfig rac: Managing the Remote Access Controller
Example Command
The following example sets one name=value pair. Type:
omconfig rac rmdialinuser username=jdoe
The following message appears:
Command Successful. Please reset RAC card!
omconfig rac rmdialoutuser
Use the omconfig rac rmdialoutuser command to remove a dial-out user. Table 8-11 shows the valid
parameters for the command.
Example Command
The following example sets one name=value pair. Type:
omconfig rac rmdialoutuser username=jdoe
The following message appears:
Command Successful. Please reset RAC card!
omconfig rac rmsnmptrap
Use the omconfig rac rmsnmptrap command to remove an SNMP trap. Table 8-12 shows the valid
parameters for the command.
Table 8-11. omconfig rac rmdialoutuser
name=value pair Description
username=<text> Specifies the user name of entry which is to be deleted. If no user name is
specified, an index must be specified.
index=<n> Specifies the index of the entry which is to be deleted. If no index is
specified, a user name must be specified.
Table 8-12. omconfig rac rmsnmptrap
name=value pair Description
ipaddr=<text> Specifies the IP address of entry which is to be deleted. This value must
be specified in dotted-decimal notation. If no IP address is specified, an
index must be specified.
index=<n> Specifies the index of the entry which is to be deleted. If no index is
specified, an IP address must be specified.