User's Manual

omconfig: Managing Components Using the Instrumentation Service 81
attribute=dbs setting=enable | disable enable: Enables Demand Based Power
Management (DBS) on the system.
disable: Disables DBS on the system.
attribute=diskette setting=off | auto | writeprotect off: Disable the diskette drive.
auto: Auto enable the diskette drive.
writeprotect
: Do not allow writes. Make
the diskette drive read only.
attribute=dualnic setting=off | onpxeboth |
onpxenone | onpxenic1 |
onpxenic2
off: The NICs are disabled.
onpxeboth: Both the NICs are PXE
enabled.
onpxenone: PXE is not enabled on
either of the NICs.
onpxenic1: PXE is enabled on NIC 1.
onpxenic2: PXE is enabled on NIC 2.
attribute=fbr setting=9600 | 19200 | 57600 |
115200
9600: Sets the console redirection failsafe
baud rate to 9600 bits per second.
19200: Sets the console redirection failsafe
baud rate to 19200 bits per second.
57600: Sets the console redirection failsafe
baud rate to 57600 bits per second.
115200: Sets the console redirection failsafe
baud rate to 115200 bits per second.
attribute=ide setting=on | off
force=true
on: Enable this device.
off: Disable this device.
force=true: Verification of setting change.
attribute=idepridrv setting=off | auto off: Disable the device.
auto: Automatically detect and enable
the device.
attribute=intrusion setting=enable | disable enable: Enable the intrusion check
during system boot. If the system also
has bezel intrusion checking, then the
intrusion option checks for removal of
the back of the system.
disable: Disable the intrusion check
during system boot.
Table 6-2. BIOS Setup (continued)
name=value pair 1
attribute=
name=value pair 2
setting=
Description