User's Manual

omreport storage: Using the Storage Reports 65
omreport storage: Using the Storage Reports
Use the omreport storage command to view information about enclosures, volumes, arrays, and
disks that are part of your storage system.
NOTE: This chapter only documents commands that are available when Array Manager is installed. See
"Using the Storage Management Service" for information on using the omreport storage command when the
enhanced Storage Management Service is installed. See the Dell OpenManage™ Server Administrator User’s
Guide for information on Array Manager and the enhanced Storage Management Service. See the Dell
OpenManage Installation and Security User's Guide for installation information.
Conventions for Parameter Tables
When listing the parameters that a command can take, the parameters are listed in alphabetical
order instead of the order in which they appear in the command line interface.
The symbol |, often called pipe, is the logical exclusive or operator. For example, enable | disable
means that you can enable or disable the component or feature, but you cannot simultaneously
enable and disable the component or feature.
omreport storage Command Summary
NOTE: Although this section lists all possible omreport storage commands, the commands available on your
system depend on your system configuration. The results that display for the omreport storage command vary
from one system to another. Data displays for installed components only.
Table 5-1 is a high-level summary of the omreport storage command. The column titled "Command
level 1" shows the omreport command at its most general. "Command level 2" shows the major
objects or components that you can view using omreport storage. "Command level 3" lists the
specific storage objects and components for which you can view reports. "User privilege required"
refers to the type of privilege you need to perform the command, where U=User, P=Power User, and
A=Administrator. "Use" is a very general statement about the actions that can be performed using
omreport storage. More details about syntax and use of the command appear later in this section.