User's Manual

omreport: Viewing System Status Using the Instrumentation Service 57
omreport system events
Use the omreport system events command to view the current enabled or disabled SNMP traps. This
command displays a summary of each component in your system for which events can be generated. For
each component, the report shows which severities are set to be reported and which severities are set not
to be reported. The following is example output for a few components:
omreport system events
Current SNMP Trap Configuration
-----------
System
-----------
Settings
Enable : Informational, Warning and Critical
Disable : None
---------------
Power Supplies
----------------
Settings
Enable : Informational, Warning and Critical
Disable : None
-----------
Fans
-----------
Settings
Enable : Critical
Disable : Informational and Warning
The full report lists the settings for all components in your system for which events can be generated.
To view the status for components of a specific type, use the omreport system events type=
<component name> command. This command displays a summary of each component in your system
for which events can be generated. Table 4-5 shows the events displayed for various component types.
NOTE: Some component types may be unavailable on your system.
Table 4-5. System Events by Component Type
name=value pair Description
type=accords Configures events for AC power cords.
type=currents Reports events for fan amperage probes.
type=fanenclosures
Reports events for fan enclosures.
type=fans Reports events for fans.
type=intrusion Reports events for chassis intrusion.