User's Manual

omreport: Viewing System Status Using the Instrumentation Service 45

omreport chassis bmc

Use the omreport chassis bmc command to view baseboard management controller (BMC)

general information.

Ty p e :

omreport chassis bmc

The output from the omreport chassis bmc command lists each of the valid parameters. Table 4-3 shows

the available settings.

Primary SCSI Displays whether the device is on or off.

RAID on motherboard Displays whether RAID-on-motherboard is detected as a RAID

device, a SCSI device, or if the device is disabled during system boot.

RAID Channel A Displays whether RAID-on-motherboard Channel A is detected as a

RAID device or a SCSI device.

RAID Channel B Displays whether RAID-on-motherboard Channel B is detected as a

RAID device or a SCSI device.

SATA Displays whether the onboard SATA controller is set to ATA mode,

RAID mode, or is disabled.

SATA port Displays if the SATA port is enabled or disabled.

Secondary SCSI Displays whether the device is enabled or disabled.

Serial Port 1 Displays whether serial port 1 is mapped to a COM port, a

COM port 1, a COM port 3, a BMC Serial, a BMC NIC, a

BMC RAC, or is disabled.

Serial Port 2 Displays whether serial port 2 is mapped to a COM port, a

COM port 2, a COM port 4, or is disabled.

Speaker Displays whether the speaker is on or off.

USB or USBB Displays whether the USB port is enabled or disabled.

Table 4-3. omreport chassis bmc

name=value pair Description

config=advsol Reports advanced BMC information on a serial over local area network