User's Manual

omreport: Viewing System Status Using the Instrumentation Service 39
fru U, P, A Shows the Field Replaceable Unit (FRU)
information.
info U, P, A Shows a status summary for main system chassis
components.
intrusion U, P, A Shows the status of the system’s intrusion
sensor(s).
leds U, P, A Shows the properties you have set for LEDs to
flash under various alert conditions.
memory U, P, A Shows properties of your system's memory arrays.
nics U, P, A Shows number of NICs installed in your system,
NIC vendor, NIC description, IP address, and
connection status.
ports U, P, A Shows properties for your system’s parallel and
serial ports, such as I/O address, IRQ level,
connector type, and maximum speed.
processors U, P, A Shows properties of your system’s processors,
including speed, manufacturer, and
processor family.
pwrsupplies U, P, A Shows properties of power supplies.
slots U, P, A Shows properties of your system’s expansion slots
and other slot types.
temps U, P, A Shows the status and thresholds for the system
temperature sensors.
volts U, P, A Shows the status and thresholds for the system
voltage sensors.
storage A See "omreport storage: Using the Storage
Reports" and "Using the Storage Management
Service."
system U, P, A Shows a high-level summary of system
components.
alertaction U, P, A Shows warning and failure threshold values, as
well as actions that have been configured when
an essential components detects a warning or
failure state.
alertlog U, P, A Allows the administrator to show the alert log.
Table 4-1. omreport Command Level 1, Level 2, and Level 3 (continued)
Command
level 1
Command
level 2
Command
level 3
User
privilege
required
Use