User's Manual

20 omdiag: Using the Diagnostic Service
system any level 3
command
for chassis
or storage
Runs the test for specified chassis or storage
component.
passes=<n> Runs a test n time(s).
time=
<minutes>
Runs a test for the specified number of minutes
<minutes>.
quicktest=
<true /false>
Uses a faster algorithm to conduct a specific test
if one is available.
haltonerror=
<true/false>
Stops the tests if an error is encountered.
Device=
<number>
Specifies the device on which to run test.
chassis cmos
memory
modem
network
parallelport
pci
serialport
rac
usbctrl
Runs the CMOS test.
Runs the memory test.
Runs the modem test.
Runs the NIC test.
Runs the parallel port test.
Runs the PCI test.
Runs the serial port test.
Runs the RAC test.
Tests the Universal Serial Bus (USB)
controller(s).
passes=<n> Runs a test n time(s).
time=
<minutes>
Runs a test for no more than the specified
number of minutes <minutes>.
quicktest=
<true/false>
Uses a faster algorithm to conduct a specific test
if one is available.
haltonerror=
<true/false>
Stops the tests if an error is encountered.
Device=
<number>
Specifies the device on which to run test.
Table 3-1. omdiag Command Level 1, Level 2, and Level 3 (continued)
Command
level 1
Command
level 2
Command
level 3
name=value
pair
Use