User's Manual
170 Using the Storage Management Service
omconfig Set Enclosure Asset Tag
Use the following omconfig command syntax to specify the enclosure’s asset tag:
Complete Syntax
omconfig storage enclosure action=setassettag controller=id
enclosure=<ENCLOSUREID> assettag=<string>
where id is the controller ID. The <ENCLOSUREID> variable specifies the enclosure.
In this syntax, <string> is a user-specified alphanumeric string.
Example for SCSI, SATA, and ATA Controllers:
For example, to specify the asset tag on the enclosure attached to connector 2 on controller 1 to encl20,
you would enter:
omconfig storage enclosure action=setassettag controller=1
enclosure=2 assettag=encl20
Example for SAS Controllers:
For example, to specify the asset tag on enclosure 3 attached to connector 2 on controller 1 to encl20,
enter:
omconfig storage enclosure action=setassettag controller=1
enclosure=2:3 assettag=encl20
omconfig Set Enclosure Asset Name
Use the following omconfig command syntax to specify the asset name for an enclosure.
Complete Syntax
omconfig storage enclosure action=setassetname controller=id
enclosure=<ENCLOSUREID> assetname=<string>
where id is the controller ID. The <ENCLOSUREID> variable specifies the enclosure.
In this syntax, <string> is a user-specified alphanumeric string.
Example for SCSI, SATA, and ATA Controllers:
For example, to specify the asset name for the enclosure attached to connector 2 on controller 1 to
encl43, enter:
omconfig storage enclosure action=setassetname controller=1
enclosure=2 assetname=encl43