User's Manual

164 Using the Storage Management Service
omconfig Clear Array Disk
Use the following omconfig command to clear data or a configuration from an array disk.
Complete Syntax
omconfig storage adisk action=clear controller=id adisk=<ADISKID>
where id is the controller ID. The <ADISK> variable specifies the array disk.
To obtain these values, enter omreport storage controller to display the controller IDs and then enter
omreport storage adisk controller=ID to display the IDs for the array disks attached to the controller.
Example Syntax
In this example, you want to clear array disk 3 on connector 0 of controller 1. On a SAS controller, the
array disk resides in enclosure 2.
Example for SCSI, SATA, and ATA Controllers:
To clear the array disk described in this example, enter:
omconfig storage adisk action=clear controller=1 adisk=0:3
Example for SAS Controllers:
To clear the array disk described in this example, you would enter:
omconfig storage adisk action=clear controller=1 adisk=0:2:3
omconfig Cancel Clear Array Disk
Use the following omconfig command to cancel a clear operation that is in progress on an array disk.
Complete Syntax
omconfig storage adisk action=cancelclear controller=id adisk=
<ADISKID>
where id is the controller ID. The <ADISK> variable specifies the array disk.
To obtain these values, enter omreport storage controller to display the controller IDs and then enter
omreport storage adisk controller=ID to display the IDs for the array disks attached to the controller.