Users Guide

Table Of Contents
Support for BOSS RAID Controllers
All Operating Systems compatible are supported by BOSS RAID Controllers.
The BOSS RAID Controllers supports the following enumeration and monitoring operations:
The physical disks (M.2 devices) are directly connected to the Controller.
Enumeration of Physical Disks on M.2 devices are supported.
Enumeration of Virtual Disks on M.2 devices are supported.
Physical disks operations or tasks for Blink and Unblink are supported only for BOSS-S2 (M.2 devices) controller.
Hot-plug insertion and hot-plug removal is supported on BOSS-S2 (M.2 devices) controller.
NOTE: Storage Management updates the M.2 device firmware everyday at 12.00 am.
The following tasks are not supported:
Configuration options are not supported for this controller.
Enclosures and connectors are not applicable for the Controller.
Physical disks operations / tasks are not supported for BOSS-S1 Controller.
No configuration operations are supported for virtual disks including creation, deletion, reconfiguration and so on.
No controller tasks are supported.
The following physical disks properties are enumerated for this controllers: ID, Status, Name, State, Bus Protocol, Media,
Revision, Model Number, Capacity, Used RAID Disk Space, Available RAID Disk Space, Hot Spare, Vendor ID, Product ID, Serial
No., Negotiated Speed, Capable Speed, Sector Size, SAS Address and Remaining Rated Write Endurance.
NOTE: SAS Address is not available for M.2 devices.
The following controller properties are enumerated for this controllers: ID, Status, Name, Slot ID, State, Firmware Version, and
Patrol Read Rate.
NOTE:
Even though the Rebuild Rate is displayed in the OM GUI and CLI, please do not consider the same. This property
will not be enumerated.
The following virtual disk properties are enumerated for this controllers: Status, Name, State, Tasks, Layout, size, Device Name,
Bus Protocol, Media, Write Policy, Stripe Element Size, Read Policy, and Disk Cache Policy.
NOTE: Layout option will not be available for non-RAID disks.
NOTE: For BOSS-S1 RAID Controller, the physical disk is directly connected to the controller as no enclosure or connector
is applicable for this controller.
NOTE: Any configuration operations through Server Administrator are not supported for virtual disks, physical disks and
controllers.
9
Support for BOSS RAID Controllers 91