Users Guide

Blinking And Unblinking A PCIe SSD
The Blink task allows you to find a device within a system by blinking one of the LEDs on the device. You can use this task
to locate a failed device. Select Unblink to cancel the Blink task or to stop the LED on a physical device that is blinking
indefinitely.
Enabling Full Initialization On A Micron PCIe SSD
Does my controller support this feature? See Supported Features.
CAUTION: Full Initialization permanently erases all data present on the disk.
CAUTION: On VMware ESXi hosts, before performing Full Initialization on the Micron PCIe SSD it is important
to first delete any data stores on it. Failure to do so can result in system instability.
To erase an encrypted physical device, select the Full Initialization task. This task is available for:
● Unconfigured SED drive
● Foreign configured encrypted drives
● Unconfigured and foreign SED drive even when an Encryption Key is not present in the controller
Related Tasks
● Performing A Full Initialization On A Micron PCIe SSD
Performing A Full Initialization On A Micron PCIe SSD
Performing a Full Initialization on a Micron PCIe SSD overwrites all blocks and results in permanent loss of all data on the Micron
PCIe SSD. During Full Initialization, the host is unable to access the Micron PCIe SSD.
NOTE:
If the system reboots or experiences a power loss during Full Initialization, the operation is canceled. You must
reboot the system and restart the process.
Related Task
● To Locate Full Initialization In Storage Management
To Locate Full Initialization In Storage Management
To locate this task in storage management:
1. In the Server Administrator window, under the system tree, expand Storage to display the controller objects.
2. Expand a controller object.
3. Expand the enclosure or backplane object.
4. Select the Physical Devices object.
5. Select Full Initialization from the Tasks drop-down menu of the physical device you want to clear.
6. Click Execute.
Preparing To Remove A PCIe SSD
PCIe SSDs support orderly hot swap allowing you to add or remove a device without halting or rebooting the system in which
the devices are installed.
CAUTION:
The identify LED pattern (blink operation) is the same LED pattern as safe to remove. When you
initiate a Prepare to Remove operation, ensure that the PCIe SSD is no longer accessible by the system before
physically removing the PCIe SSD.
CAUTION: To prevent data loss, it is mandatory that you use the Prepare to Remove task before physically
removing a device.
PCI Express Solid-State Device Support 37