CLI Guide

Table 64. Valid Parameters Of Omconfig Preferences Webserver (continued)
name=value pair 1 name=value pair 2 Description
values. The changes to take effect after
web server restart.
attribute=<port> setting=<valid port value>
Sets the number of secure ports that you
want Server Administrator to use. The
port value range from 1024 to 65535. The
default port for Server Administrator is
1311.
attribute=<ipaddress> setting=<valid Binding IPAddress value>
Sets by default the web server to
incoming browser requests on ALL
IP addresses. However, for increased
security you can specify a single IP
address or, ALL IP addresses. An error
message is displayed on an invalid entry of
the configurable Bind List of IP Address.
For the changes to take effect, restart
the web server.
attribute=<sessiontimeout> setting=<valid Session Timeout value
between 1– 30>
Allows Server Administrator to time-out
if there is no user input for a specified
number of minutes. Users whose sessions
time-out must log in again to continue.
An example command to set the URL launch point is as follows:
omconfig preferences webserver attribute=seturl host=<name, ip, fqdn> port=<number>
The host input must contain a valid IPv4 or IPv6 address, or a valid host name.
An example command to set the signing algorithm value is as follows:
omconfig preferences webserver attribute=signalgorithm setting=MD5
An example command to set the JRE versions is as follows:
omconfig preferences webserver attribute=setjre jreversion=<bundled | value>
An example command to export a Certificate Signing Request (CSR) is as follows:
omconfig preferences webserver attribute=exportcsr
The command creates a file of the format xxxx.csr in the <Server Administrator installation directory>\apache-tomcat\temp
folder.
An example command to create a web server certificate is as follows:
omconfig preferences webserver attribute=gennewcert cn=HostName org=dell ou=ESG
location=RoundRock state=TX country=US validity=300 keysize=2048 algorithm=SHA512
webserverrestart=true
An example command to create a web server certificate with san is as follows:
omconfig preferences webserver attribute=gennewcert cn=HostName org=dell ou=ESG
location=RoundRock state=TX country=US san=alternate domain name validity=300
keysize=2048 algorithm=SHA512 webserverrestart=true
An example command to upload a certificate on the Server Administrator web server is as follows:
omconfig preferences webserver attribute=uploadcert certfile=C:/xyz.crt
webserverrestart=true
96
Omconfig Managing Components Using The Instrumentation Service