CLI Guide

Table 55. Valid Parameters Of Omconfig Chassis Remoteaccess Or Omconfig Mainsystem Remoteaccess
(continued)
name=value pair 1
config=
name=value pair 2 Description
operator: Sets the maximum privilege level that is
accepted on a LAN channel, to Operator.
user: Sets the maximum privilege level that is accepted
on a LAN channel, to User.
encryptkey=text
confirmencryptkey=text
text: Text used for encryption and confirmation of
encryption.
prefdnsserverv6=<value> Validates the preferred DNS server for configuration.
config=serial
baudrate=9600 | 19200 | 38400 |
57600 | 115200
9600: Sets the connection speed to 9600 bits per
second.
19200: Sets the connection speed to 19200 bits per
second.
38400: Sets the volatile and non-volatile connection
speed to 38400 bits per second.
57600: Sets the volatile and non-volatile connection
speed to 57600 bits per second.
115200: Sets the volatile and non-volatile connection
speed to 115200 bits per second.
flowcontrol=none | rtscts
none: No control over the flow of communication
through the serial port.
rtscts: RTS is ready to send and CTS is clear to send.
mode=directbasic | directterminal |
directbasicterminal | modembasic |
modemterminal | modembasicterminal
directbasic: Type of messaging used for IPMI messaging
over a serial connection.
directterminal: Type of messaging that uses printable
ASCII characters and allows a limited number of text
commands over a serial connection.
directbasicterminal: Both basic and terminal mode
messaging over a serial connection.
modembasic: Type of messaging used for IPMI
messaging over a modem.
modemterminal: Type of messaging that uses printable
ASCII characters and allows a limited number of text
commands over a modem.
modembasicterminal: Both basic and terminal
messaging over a modem.
NOTE: All commands may not be supported on the
system.
privilegelevel=administrator | operator |
user
administrator: Sets the maximum privilege level that are
accepted on a serial connection, to Administrator.
operator: Sets the maximum privilege level that are
accepted on a serial connection, to Operator.
user: Sets the maximum privilege level that are accepted
on a serial connection, to User.
config=serialoverlan enable=true | false
true: Enables serial over LAN for the BMC.
false: Disables serial over LAN for the BMC.
Omconfig Managing Components Using The Instrumentation Service 85