CLI Guide

within normal range. Someone has raised the minimum warning threshold by 200 RPM and has decreased the maximum warning
threshold by 2000 RPM.
Selecting A Format For The CLI Command Output
You can specify a format for the CLI command results. The format determines how the command output is displayed. If the
command results are directed to a file, the format is captured by the file to which you write the command results.
The available formats include:
● List (lst)
●
Semicolon-separated values (ssv)
● Table (tbl)
● Custom delimited format (cdv)
The syntax for the formatting option is:
<command> -fmt <format option>
For example, type:
omreport system summary -fmt tbl
or
omreport servermodule summary -fmt tbl
where -fmt tbl specifies table format.
You can combine the formatting option with the option to direct output to a file. For example, type:
omreport system summary -fmt tbl -outa summary.txt
or
omreport servermodule summary -fmt tbl -outa summary.txt
where -fmt tbl specifies table format and -outa specifies that you append the command results to a file named summary.txt .
List
The default format is lst or list format. Use this format when you want to optimize output for simple readability. You need to
specify a format for the command output only if you want a format other than the lst format.
To see the following example command output in lst format, type:
omreport system summary
or
omreport servermodule summary
No special formatting option is required because list format is the default display format. The network data part of the example
system summary is displayed as follows:
--------------
Network Data
--------------
Network Interface 0
IP Address : 143.166.152.108
Subnet Mask : 255.255.255.0
Default Gateway : 143.166.152.1
MAC Address : 00-02-b3-23-d2-ca
Working With CLI Command Results
191