CLI Guide

Table 104. omreport Connector Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage connector
Displays all connectors present on all
controllers on the system.
NOTE: This command works only when
the controller ID is specified.
controller=id, where id is the
controller number. For example:
controller=0
Displays the connectors on the specified
controller.
controller=id connector=id, where
id is the connector number. For
example, connector=0
Displays the specified connector.
NOTE: When the connectors are
connected to the enclosure in redundant
path mode, the Name of the connector is
displayed as Logical Connector.
Omreport Cachecade Status
The following table describes the syntax for the omreport Cachecade commands
Table 105. omreport Cachecade Commands
Required Command Levels (1,
2, 3)
Optional name=value pairs Use
omreport storage cachecade Displays property information for all
cachecades on all controllers.
controller=id, where id is the controller
number. For example, controller=0.
Displays all cachecades on the specified
controller.
controller=id cachecade=id, where id is
the controller number and the cachecade
number. For example, controller=0
cachecade=1.
Displays the specified cachecade on the
controller.
Omreport Storage Tape
The following table describes the syntax for the omreport storage tape command.
Table 106. Omreport Storage Tape Commands
Required Command Levels (1,
2, 3)
Optional name=value pairs Use
omreport storage tape Display tape drive properties.
controller=id, where id is the controller
number. For example: controller=0.
Displays all tape drives.
connector=id Displays all the tape drives on the specified
connector.
tape=<tape id>, where
tapeid=id=<connector:targetID>
Displays the specified tape drive.
Omreport storage commands 137