CLI Guide

Table 101. Omreport Enclosure Slot Occupancy Report Commands (continued)
Required Command Levels (1, 2, 3)
and name=value pair
Optional name=value pairs Use
is the enclosure number. For example:
controller=0 enclosure=2
NOTE: This command is not
supported on Backplane, SCSI, and
SWRAID controllers.
NOTE: On MX5016s, the slot
occupancy displays for empty slots
and unmapped slots as empty slots
for computes MX740c and MX840c.
Omreport Battery Status
The following table describes the syntax for the omreport Battery commands:
Table 102. omreport Battery Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage battery Displays all batteries present on all
controllers on the system (Some
controllers do not have batteries).
controller=id, where id is the controller
number. For example: controller=0
Displays the battery on the specified
controller.
controller=id battery=id, where id is
the controller number. For example:
controller=0
Displays the specified battery.
Omreport Global Information
The following table describes the syntax for the omreport Global Information commands:
Table 103. Omreport Global Information Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage globalinfo
Displays whether smart thermal shutdown
is enabled or disabled. For more
information, see Omconfig Global Enable
Smart Thermal Shutdown.
Displays the hot spare protection policy
that you have set. For more information
on setting hot spare protection policy,
see the Dell EMC OpenManage Server
Administrator Storage Management
User’s Guide at dell.com/support/
manuals.
Omreport Connector Status
The following table describes the syntax for the omreport Connector commands:
136
Omreport storage commands