CLI Guide

Omreport controller status
The following table describes the syntax for the omreport Controller commands.
Table 95. omreport controller commands
Required command
levels (1, 2, 3)
Optional name=value pairs Use
omreport storage
controller
Displays property information for all controllers attached to the
system.
controller=id, where id is the
controller number. For example,
controller=0
Displays the specified controller and all attached components
such as enclosures, virtual disks, physical disks, HHHL cards,
and so on.
controller=id info=foreignkeyids Displays the locked foreign configuration information for import
or clear operations.
controller=id info=pdslotreport
Displays the empty and occupied slot details of enclosures in
the controller.
NOTE: This command is not supported on Backplane,
SCSI, and SWRAID controllers.
Omreport Enclosure Status
The following sections provide the omreport storage enclosure command syntax required to execute the enclosure commands.
The following table describes the syntax for the omreport Enclosure commands.
Table 96. omreport Enclosure Commands
Required Command
Levels (1, 2, 3)
Optional name=value pairs Use
omreport storage
enclosure
Displays property information for all enclosures
attached to the system.
controller=id, where id is the controller number Displays all enclosures connected to the
controller.
controller=id enclosure=<ENCLOSUREID>,
where id is the controller number and
<ENCLOSUREID>is the enclosure ID. Example
for SCSI controllers: controller=0 enclosure=2.
Example for SAS controllers: controller=0
enclosure=1:2.
Displays the specified enclosure and its
components.
Omreport Temperature Probe Status
The following table describes the syntax for the omreport Probe commands:
Table 97. omreport Temperature Probe Commands
Required Command Levels (1, 2, 3)
and name=value pair
Optional name=value pairs Use
omreport storage enclosure Displays property information for all
enclosures attached to the system.
controller=id
enclosure=<ENCLOSUREID> info=temps
where id is the controller number
and <ENCLOSUREID> is the enclosure
Displays the temperature probes for the
specified enclosure.
Omreport storage commands 133