CLI Guide

• Omreport Connector Status
• Omreport Cachecade Status
• Omreport Storage Tape
• Omreport NVMe adapter
Omreport Physical Disk Status
The following table describes the syntax for the omreport Physical Disk commands.
Table 93. Omreport Physical Disk Commands
Required Command Levels (1, 2, 3)
And name=value pair
Optional name=value pairs Use
omreport storage pdisk controller=id, where id is the controller
number. For example, controller=0
Displays all physical disks attached to
the specified controller.
NOTE: If a physical disk was
replaced by another disk as part of
the replace member operation, the
state of the physical disk is displayed
as Replacing.
vdisk=id, where id is the virtual disk
number. For example, vdisk=1
Displays all physical disks included in the
specified virtual disk on the controller.
cachecade=id where id is the cachecade
number. For example, cachecade=1
Displays all physical disks included in the
specified cachecade on the controller.
connector=id where id is the connector
number. For example, connector=1
Displays all physical disks attached
to the specified connector on the
controller.
pdisk=connectorID: targetID |
connectorID: enclosureID: slotID, where
connectorID: targetID is the connector
number and the physical disk number
and connectorID:enclosureID: slotID
is the connector number, enclosure
number, and slot number. For example,
pdisk=0:2 or pdisk=0:1:2
Displays the specified physical disk
on the specified connector on the
controller.
omreport Virtual Disk Status
The following table describes the syntax for the omreport Virtual Disk commands:
Table 94. omreport Virtual Disk Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage vdisk Displays property information for all
virtual disks on all controllers.
controller=id, where id is the controller
number. For example, controller=0.
Displays all virtual disks on the specified
controller.
controller=id vdisk=id, where id is
the controller number and the virtual
disk number. For example, controller=0
vdisk=1.
Displays the specified virtual disk on the
controller.
132 Omreport storage commands