User's Manual

Controllers 117
To change the controller’s rebuild rate:
1 Type a numerical value in the New Rebuild Rate text box. The value must
be within the 0 – 100 range.
2 Click Apply Changes . To exit and cancel your changes, click Go Back to
Previous Page
.
To locate this task in Storage Management:
1 Expand the Storage tree object to display the controller objects.
2 Select a controller object.
3 Select the Information/Configuration subtab.
4 Select Set Rebuild Rate from the Available Tasks drop-down menu.
5 Click Execute .
You can also locate this task from the Change Controller Properties drop
down menu. For more information, see
Change Controller Properties .
Reset Configuration
Does my controller support this feature? See Supported Features .
Use the Reset Configuration task to erase all information on the controller so
that you can perform a fresh configuration. This operation destroys all data
and virtual disks on the controller and unassigns any hot spares.
You must completely reconfigure your storage after performing this operation.
CAUTION: Resetting a configuration permanently destroys all data on all virtual
disks attached to the controller. If the system or boot partition resides on these
virtual disks, it is destroyed.
NOTE: Resetting the controller configuration does not remove a foreign
configuration. To remove a foreign configuration, use the Clear Foreign
Configuration task.