SNMP Reference Guide

744 Traps
Memory device bank
location:
<Bank name in chassis>
Specifies the name of the memory bank in the
system that generated the message, for
example:
Memory device bank location:
Bank_1
Memory device location:
<Device name in
chassis>
Specifies the location of the memory module
in the chassis, for example:
Memory device location: DIMM_A
Number of devices
required for full
redundancy: <Number>
Specifies the number of power supply or
cooling devices required to achieve full
redundancy, for example:
Number of devices required for
full redundancy: 4
Peak value (in Watts):
<Reading>
Specifies the peak value in Watts, for example:
Peak value (in Watts): 125
Possible memory module
event cause: <list of
causes>
Specifies a list of possible causes for the
memory module event, for example:
Possible memory module event
cause: Single bit warning error
rate exceeded
Single bit error logging disabled
Power Supply type:
<type of power supply>
Specifies the type of power supply, for example:
Power Supply type: VRM
Pre-failure state was:
<State>
Specifies the status of the previous memory
message, for example:
Pre-failure state was: Failed
Previous redundancy
state was: <State>
Specifies the status of the previous redundancy
message, for example:
Previous redundancy state was:
Lost
Previous state was:
<State>
Specifies the previous state of the sensor, for
example:
Previous state was: OK (Normal)
Description Line Item Explanation
book.book Page 744 Wednesday, March 6, 2013 12:37 AM