Read me

4. Type:
omconfig system webserver action=start
* Issue 13: A temperature drop below a minimum failure threshold does not cause
a system reset even if this alert action is set.
* Issue 14: Clicking the "Back" and "Refresh" buttons on the browser may not
display the correct page with respect to the Server Administrator component
tree, tabs, tab menus, or help, as Server Administrator has been designed with
limited functionality to reduce overhead.
Full feature capabilities of the Web browser such as "Back", "Refresh", and
"Open in New Window" may not be supported.
* Issue 15: Selecting the boot sequence under the BIOS "Setup" tab does not
re-enable boot devices that have been disabled in the System Setup Program,
earlier.
* Issue 16: The links on the Server Administrator home page may not work after
repeated random clicking.
To resolve this issue, refresh the browser by pressing <F5> or click the
browser "Refresh" button.
* Issue 17: All unsecured HTTP requests to Server Administrator receive an
invalid response. Server Administrator runs only one instance of the Web
server, which is secure. Make all connections through
https://<ip address> : <port number>. Any "http://<ip address>: <port number>"
request for connection with the server receives an invalid response.
* Issue 18: If the browser used with Server Administrator does not display a
page or perform an action, make sure that the browser is in online mode. To go
online, perform the following:
- In Internet Explorer, on the menu bar, click "File" and
clear the "Work Offline" option. When "Work Offline" is selected, a check
mark is displayed to the left of the option on the "File" menu.
* Issue 19: If Internet Explorer prompts you to "Work Offline", "Connect", or
"Try Again", always select "Connect" or "Try Again". Do not select
"Work Offline".
* Issue 20: While setting dates in the "Asset Information" section of the
Server Administrator home page, the current time is appended to the date.
While setting dates with the CLI, the appended time is noon.
* Issue 21: On some systems, temperature probe values and settings are only
supported for whole degrees, not tenths of a degree. On these systems, setting
a fractional value for the minimum warning temperature threshold results in
the set value being rounded down to the next whole number value. This behavior
may cause the minimum warning threshold to have the same value as the minimum