Command Line Interface Guide

omconfig: Managing Components Using the Instrumentation Service 97
Help With the omconfig Command
Use the omconfig -? command to get a list of the available commands for
omconfig.
Use omconfig <command level 2> -? to get help on the about, chassis,
preferences, and system’s level 2 commands. The following information on
omconfig system -? applies equally to getting help for the omconfig chassis
command.
Use the omconfig system -? command to get a list of the available commands
for omconfig system.
Use the omconfig preferences -? command to get a list of the available
commands for omconfig preferences, such as cdvformat, which is the custom
delimiter format (cdv). Type the following command to display the list of
delimiter values for the cdv:
omconfig preferences cdvformat -?
volts P, A Sets warning threshold
values default or a specific
value.
NOTE: You cannot change
threshold values on ESM3
and PowerEdge
x 8 xx
systems.
storage See "Using the Storage
Management Service" on
page 197.
Table 4-2. omconfig Command Level 1, Level 2, and Level 3 (continued)
Command
Level 1
Command
Level 2
Command Level 3 User
Privilege
Required
Use