Command Line Interface Guide

68 omreport: Viewing System Status Using the Instrumentation Service
The output of the omreport chassis remoteaccess or omreport mainsystem
remoteaccess command lists each of the valid parameters. Table 3-6 lists the
available settings.
omreport chassis slots or omreport mainsystem slots
Use the omreport chassis slots or omreport mainsystem slots command to
view properties of the system’s slots.
Ty p e :
omreport chassis slots index=n
or
omreport mainsystem slots index=n
The index parameter is optional. If you do not specify the index, Server
Administrator displays properties for all of the slots in the system. If you
specify the index, Server Administrator displays properties for a specific slot.
NOTE: To maintain consistency across the commands, the output format of this
command has changed. Change the user scripts as applicable.
Table 3-6. Valid parameters of omreport chassis remoteaccess or omreport
mainsystem remoteaccess
name=value pair Description
config=additional Reports the current state of IPv4 and IPv6 addresses on
iDRAC.
config=advsol Reports advanced BMC/iDRAC or remote access information
on a serial over local area network (LAN) connection.
config=nic Reports BMC/iDRAC or remote access information for the
LAN.
config=serial Reports serial port information for BMC or remote access.
config=serialoverlan Reports BMC/iDRAC or remote access information on a serial
over LAN connection.
config=
terminalmode
Reports terminal mode settings for the serial port.
config=user Reports information on BMC/iDRAC or remote access users.