Command Line Interface Guide

56 omreport: Viewing System Status Using the Instrumentation Service
If the system supports redundant memory, the redundancy output may
resemble the following:
omreport chassis nics or omreport mainsystem nics
Use the omreport chassis nics or omreport mainsystem nics command to
view NIC and Team interface details. On XenServer, the command displays
all the installed NICs, regardless of driver installation.
NOTE: The order in which devices are detected is not guaranteed to match the
physical port ordering of the device.
To view NIC properties, type:
omreport chassis nics index=n
or
omreport mainsystem nics index=n
Memory Redundancy
Redundancy Status
Fail Over State
Redundancy
Configuration
Attributes of Memory
Array(s)
Attributes
Memory Array 1
Attributes
Memory Array 1
Attributes
Memory Array 1
Attributes
Memory Array 1
Attributes
Memory Array 1
Attributes
Memory Array 1
Attributes
Memory Array 1
: Full
: Inactive
: DDDC
: Location
: System Board or Motherboard
: Use
: System memory
: Installed Capacity
: 131072 MB
: Maximum Capacity
: 1048576 MB
: Slots Available
: 32
: Slots Used
: 32
: Error Correction
: Multibit ECC