Command Line Interface Guide

omreport: Viewing System Status Using the Instrumentation Service 47
To view all available boot devices, alias names, and boot order sequences,
type:
omreport chassis biossetup attribute=bootorder
NOTE: In Linux systems, user or user groups upgraded to administrator or
administrator groups cannot view the boot order sequence.
RAID on motherboard Displays whether RAID-on-motherboard is detected as a
RAID device, a SCSI device, or if the device is disabled
during system boot.
RAID Channel A Displays whether RAID-on-motherboard Channel A is
detected as a RAID device or a SCSI device.
RAID Channel B Displays whether RAID-on-motherboard Channel B is
detected as a RAID device or a SCSI device.
SATA
Serial Port 1 Displays whether serial port 1 is mapped to a COM port, a
COM port 1, a COM port 3, a COM1 BMC, a BMC Serial,
a BMC NIC, a BMC RAC, or is disabled.
Serial Port 2 Displays whether serial port 2 is mapped to a COM port, a
COM port 2, a COM port 4, or is disabled.
Speaker Displays whether the speaker is on or off.
USB or USBB Displays whether the USB port is enabled or disabled.
Secondary SCSI Displays whether the device is enabled or disabled.
Serial Communications Displays whether COM port 1 and COM port 2 are off or on
with or without console redirection.
Console Redirection
After Boot
Displays whether console redirection after system reboot is
enabled or disabled.
External Serial
Connector
Displays whether the external serial connector is mapped to
Serial Device 1, Serial Device 2, or a Remote Access Device.
Console Redirection
Failsafe Baud Rate
Displays the setting for console redirection failsafe baud
rate.
Serial Address Select Displays port address for the serial devices.
Table 3-3. BIOS Setup Parameters on Systems Prior to Dell PowerEdge yx2x
System
(continued)
Parameters Description