Command Line Interface Guide

46 omreport: Viewing System Status Using the Instrumentation Service
Operating System
Watc hdog Time r
Displays whether the operating system watchdog timer is
enabled or disabled.
HT Assist Displays the status of the probe filter chipset option.
Internal SD Card Displays whether the internal SD card is enabled or
disabled.
Bezel Displays whether the bezel removal intrusion check during
system reboot is enabled or disabled.
Console Redirection Displays whether the BIOS screen is redirected over a
particular serial port or if it is turned off.
Diskette Displays whether the diskette is disabled, auto enabled, or
read-only.
Demand Based Power
Management (DBS)
Displays whether DBS is enabled or disabled on the system.
Embedded Hypervisor Displays whether the embedded hypervisor is enabled or
disabled.
IDE Displays whether the drive is enabled or disabled.
IDE Primary Drive 0 Displays whether the device is automatically detected and
enabled or if the device is disabled.
IDE Primary Drive 1 Displays whether the device is automatically detected and
enabled or if the device is disabled.
Intrusion Displays whether the intrusion check is enabled or disabled
during system boot.
Mouse Displays whether the mouse is enabled or disabled.
Optical Drive
Controller
Displays whether the optical drive controller is enabled or
disabled.
Parallel port address Displays whether the address is located on LPT1, LPT2, and
LPT3, or if it is disabled.
Parallel port mode Displays the setting associated with the parallel port.
Primary SCSI Displays whether the device is on or off.
Table 3-3. BIOS Setup Parameters on Systems Prior to Dell PowerEdge yx2x
System
(continued)
Parameters Description