Command Line Interface Guide

omreport: Viewing System Status Using the Instrumentation Service 45
User accessible USB
Ports
Displays whether the user-accessible USB port is enabled or
disabled.
CPU Virtualization
Technology
Displays the additional hardware capabilities provided by
Virtualization Technology.
AC Power Recovery
Mode
Displays the system state when input power is restored after
an outage.
Embedded SATA
Controller
Displays whether the embedded SATA controller is set to
ATA mode, RAID mode, or is disabled.
SATA Port 0 Displays the state of SATA port 0.
SATA Port 1 Displays the state of SATA port 1.
Dual NIC (1/2) Displays whether NIC 1 and NIC 2 with PXE/iSCSI is
enabled or disabled.
Dual NIC (3/4) Displays whether NIC 3 and NIC 4 with PXE/iSCSI is
enabled or disabled.
NIC 1 Displays whether the first NIC is enabled (with or without
PXE/iSCSI) or disabled during system boot.
NIC 2 Displays whether the second NIC is enabled (with or
without PXE/iSCSI) or disabled during system boot.
NIC 3 Displays whether the third NIC is enabled (with or without
PXE/iSCSI) or disabled during system boot.
NIC 4 Displays whether the fourth NIC is enabled (with or
without PXE/iSCSI) or disabled during system boot.
Trusted Cryptographic
Module (TCM)
Displays whether TCM is on or off.
Trusted P latf orm
Module (TPM)
Security
Displays whether TPM is off, on with pre-boot
measurements, or on without pre-boot measurements.
Internal USB Port
(number)
Displays whether the internal USB is enabled or disabled.
NOTE: Server Administrator may not display the USB
sequence number if there is only one USB port on the system.
Table 3-3. BIOS Setup Parameters on Systems Prior to Dell PowerEdge yx2x
System
(continued)
Parameters Description