Command Line Interface Guide

32 omreport: Viewing System Status Using the Instrumentation Service
Conventions for Parameter Tables
When listing the parameters for a command, the parameters are listed in
alphabetical order instead of the order in which they appear in the command
line interface (CLI).
The symbol |, often called pipe, is the logical exclusive or operator.
For example, enable | disable means enable or disable the component or
feature.
Command Summary of the omreport Command
Although this chapter lists all possible omreport commands, the commands
available on the system depend on the system configuration. The results of
the omreport command may vary from one system to another. The omreport
command displays data for the installed components only.
NOTE: When a system includes an external chassis, the displayed results vary by
operating system. On SUSE Linux Enterprise Server and Red Hat
Enterprise Linux
systems, omreport commands display external chassis information in a separate
section after the main chassis information. On Microsoft Windows systems, data
about the external chassis does not appear in the omreport output.
Table 3-2 provides a high-level summary of the omreport command. The
column titled Command level 1 shows the omreport command at its most
general use. Command level 2 shows the major objects or components that
you can view using omreport (about, chassis, storage, and system).
Command level 3 lists the specific objects and components to view reports.
User privilege required refers to the type of privilege you need to run the
command, where U=User, P=Power User, and A=Administrator. Use is
a very general statement about the actions performed using omreport. More
details about the syntax and use of the command appear later in this section.
Table 3-2 l i s ts the omreport commands available for about, system, and main
system chassis. For information about viewing storage components,
see "omreport: Viewing System Status Using the Instrumentation Service" on
page 31.