Command Line Interface Guide

omconfig storage Commands 277
omconfig Set Enclosure Asset Name
Use the following omconfig command syntax to specify the asset name for an
enclosure.
Complete Syntax
omconfig storage enclosure action=setassetname
controller=id enclosure=<ENCLOSUREID> assetname=
<string>
where id is the controller ID. The <ENCLOSUREID> variable specifies the
enclosure.
In this syntax, <string> is a user-specified alphanumeric string.
Example Syntax
To specify the asset name to encl43 for the enclosure attached to connector 2
on controller 1:
• For SCSI, SATA, and ATA controllers:
omconfig storage enclosure action=setassetname
controller=1 enclosure=2 assetname=encl43
• For SAS controllers:
omconfig storage enclosure action=setassetname
controller=1 enclosure=1:2 assetname=encl43
omconfig Set Temperature Probe Thresholds
Use the following omconfig command syntax to set the minimum and
maximum warning temperature thresholds for a specified temperature probe.
NOTE: This command is not supported on SAS controllers.