Command Line Interface Guide

252 omconfig storage Commands
omconfig Rescan Controller
Use the following omconfig command syntax to rescan a controller. For more
information, see the Dell OpenManage Online Help.
Complete Syntax
omconfig storage controller action=rescan
controller=id
where id is the controller ID as reported by the omreport storage controller
command.
Example Syntax
To rescan controller 1, type:
omconfig storage controller action=rescan
controller=1
NOTE: The rescan controller is not supported on non-RAID SCSI and SAS
controllers. Reboot the system to make the configuration changes visible on non-
RAID SCSI controllers.
omconfig Enable Controller Alarm
Use the following omconfig command syntax to enable the controller alarm.
See the Dell OpenManage Online Help for more information about Enable
Controller Alarm.
action=switchtolkm controller=id keyid=<keyid>
passphrase=<passphrase string> [escrow=yes] [filepath=
<Absolute path to the escrow file>]
NOTE: If you set escrow=yes, specify the escrow file path.
action=rekeylkm controller=id
action=convertraidtononraid controller=id pdisk=
<PDISKID>
action=convertnonraidtoraid controller=id pdisk=
<PDISKID>
Table 8-4. omconfig Controller Commands
(continued)
Required Command Levels
(1, 2, 3)
Optional name=value pairs