Command Line Interface Guide

omconfig storage Commands 249
omconfig Reactivate Fluid Cache on Virtual Disk
Use the following omconfig command syntax to reactivate the fluid cache for
the specified virtual disk.
Complete Syntax
omconfig storage vdisk action=reactivate
controller=id vdisk=id devicename=<string>
where id is the controller ID and virtual disk ID as reported by the omreport
command, and <string> is the device name of the virtual disk. To obtain the
values for controller ID and virtual disk ID, type omreport storage controller
to display the controller IDs and then type omreport storage vdisk
controller=ID to display the IDs for the virtual disks attached to the controller.
Example Syntax
To reactivate fluid cache on virtual disk 4 on controller 1, type:
omconfig storage vdisk action=reactivate controller=
1 vdisk=4 devicename=/dev/sdb
omconfig Controller Commands
The following sections provide the omconfig command syntax required to
execute controller tasks.
CAUTION: The omconfig storage controller action=resetconfig controller=id
resets the controller configuration. Resetting the controller configuration
permanently destroys all data on all virtual disks attached to the controller. System
or boot partition residing on these virtual disks is destroyed.
Table 8-4. omconfig Controller Commands
Required Command Levels
(1, 2, 3)
Optional name=value pairs
omconfig storage
controller
action=rescan controller=id
action=enablealarm controller=id
action=disablealarm controller=id
action=quietalarm controller=id