Command Line Interface Guide

238 omconfig storage Commands
Complete Syntax
omconfig storage vdisk action=slowinit controller=
id vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport
command. To obtain these values, type omreport storage controller to display
the controller IDs and then type omreport storage vdisk controller=ID to
display the IDs for the virtual disks attached to the controller.
In some circumstances, you may receive a warning message if this command
deletes the system or boot partition. You can override this warning by using
the force=yes parameter. In this case, the syntax is as follows:
omconfig storage vdisk action=slowinit controller=
id vdisk=id force=yes
Example Syntax
To slow initialize virtual disk 4 on controller 1, type:
omconfig storage vdisk action=slowinit controller=
1 vdisk=4
omconfig Cancel Initialize Virtual Disk
Use the following omconfig command syntax to cancel the initialization of a
virtual disk.
Complete Syntax
omconfig storage vdisk action=cancelinitialize
controller=id vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport
command. To obtain these values, type omreport storage controller to display
the controller IDs and then type omreport storage vdisk controller=ID to
display the IDs for the virtual disks attached to the controller.
Example Syntax
To cancel the initialization of virtual disk 4 on controller 1, type:
omconfig storage vdisk action=cancelinitialize
controller=1 vdisk=4