Command Line Interface Guide

omconfig storage Commands 231
Example Syntax
To convert RAID to non-RAID on physical disk 3 on connector 0 of
controller 1:
• For SAS controllers:
omconfig storage pdisk action=raidtononraid
controller=1 pdisk=0:2:3
NOTE: On a SAS controller, the physical disk resides in enclosure 2.
omconfig Convert Non-RAID to RAID
Use the following omconfig command to convert non-RAID to RAID on a
physical disk.
Complete Syntax
omconfig storage pdisk action=convertnonraidtoraid
controller=id pdisk=<PDISKID>
where id is the controller ID. The <PDISKID> variable specifies the
physical disk.
To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.
NOTE: To convert multiple non-RAID to RAID on a given controller, use omconfig
storage controller action=convertnonraidtoraid command. For more information,
see "omconfig Convert Multiple Non-RAID to RAID" on page 273.
Example Syntax
To convert non-RAID to RAID on physical disk 3 on connector 0 of
controller 1:
• For SAS controllers:
omconfig storage pdisk action=nonraidtoraid
controller=1 pdisk=0:2:3
NOTE: On a SAS controller, the physical disk resides in enclosure 2.