Command Line Interface Guide

omconfig storage Commands 227
To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.
Example Syntax
To cancel replace member operation on disk 0:0:1 which is connected to
controller 0, type:
omconfig storage pdisk action=cancelreplacemember
controller=0 pdisk=0:0:1
omconfig Clear Physical Disk
Use the following omconfig command to clear data or a configuration from a
physical disk.
Complete Syntax
omconfig storage pdisk action=clear controller=id
pdisk=<PDISKID>
where id is the controller ID. The <PDISKID> variable specifies the
physical disk.
To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.
Example Syntax
To clear the physical disk 3 on connector 0 of controller 1:
• For SCSI, SATA, and ATA controllers:
omconfig storage pdisk action=clear controller=1
pdisk=0:2:3
omconfig Cancel Clear Physical Disk
Use the following omconfig command to cancel a clear operation in progress
on a physical disk.