Command Line Interface Guide

226 omconfig storage Commands
omconfig Cancel Rebuild Physical Disk
Use the following omconfig command syntax to cancel a rebuild that is in
progress. If you cancel a rebuild, the virtual disk remains in a degraded state.
See the Dell OpenManage Online Help for more information about Cancel
Rebuild Physical Disk.
Complete Syntax
omconfig storage pdisk action=cancelrebuild
controller=id pdisk=<PDISKID>
where id is the controller ID. The <PDISKID> variable specifies the
physical disk.
To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.
Example Syntax
To cancel the rebuild of the physical disk 3 on connector 0 of controller 1:
• For SCSI, SATA, and ATA controllers:
omconfig storage pdisk action=cancelrebuild
controller=1 pdisk=0:3
• For SAS controllers:
omconfig storage pdisk action=cancelrebuild
controller=1 pdisk=0:2:3
NOTE: On a SAS controller, the physical disk resides in enclosure 2.
omconfig Cancel Replace Member
Use the following omconfig command syntax to cancel a replace member
operation.
Complete Syntax
omconfig storage pdisk action=cancelreplacemember
controller=id pdisk=<PDISKID>
where id is the controller ID. The <PDISKID> variable specifies the
physical disk.